QUICK cut and form knurling and roll marking, built by Hommel + Keller and supplied here through Platinum Tooling. Cut knurling for visual work, thin-walled parts and difficult materials, with zero or minimal alteration to the workpiece diameter. Form knurling anywhere on the part, up to a shoulder, on the face or internally, as a chip-free cold-forming process. Roll marking that puts part numbers, batch data and logos on in-cycle on most CNC turning and milling centres instead of as a secondary operation. Swiss-type work is covered down to small diameters. Supplied and supported through ISG.
Knurling and marking are secondary operations that shouldn't need a second setup. Done in-cycle, they cost seconds; done off-line, they cost a handling step and a chance to scrap a finished part.
Hommel + Keller QUICK · cut knurling
Cutting the knurl rather than forming it — the answer when the part is thin-walled, the material is difficult, or the diameter must not move.
Hommel + Keller QUICK · form knurling
Cold-formed, chip-free knurling that can go almost anywhere on the part — up to a shoulder, on the face, or inside a bore.
Part marking in-cycle
Part numbers, batch data, article names and logos rolled on during the machining cycle rather than in a secondary operation.
Small-diameter work
The same QUICK program taken down to Swiss diameters, where a forming load the part cannot take is the usual reason knurling gets sent out.
Browse the manufacturer's complete range, then quote it through MS² — with application support from people who run these products, not just ship them.
